Mamorubot Polypropylene plate. Sizes to suit Artillery Genius & X1

SKU 10115
$21.95
In stock
1
Product Details

Mamorubot 235x235 suit Genius

  • The Mamorubot Polypropylene Build Plate is a 3d printer build plate to be used instead of glass, mirror beds or adhesive surfaces. It is a build plate that offers consistent and reliable prints.
    Can be attached directly to your glass bed using clips or tape.
    How to use your new polypropylene build plate ?
    Note: the polypropylene build plate has different properties than a glass or mirror plate.
    1) Remove old build plate
    2) Make sure bed is level and flat in all directions
    3) Install your new polypropylene build plate and make sure it is securely fastened to the print bed.
    4) If you have a heated bed, please heat bed to normal operating temperature for 5 minutes.
    5) When bed is heated, double check for flatness.
    6) Perform your leveling routine. Bed may require adjustments to level due to differences in plate thickness
    7) Note that some adjustment to previous bed temperature settings may be required. Make test prints to verify proper adhesion.

    Note: If you see reduction in adhesion, please clean with Isopropyl alcohol and a clean cloth.
    Suggested Bed temperatures may vary depending on filament material.
    Temperature settings for different filaments:
    1. PLA:50-70℃
    2. Flexible filament: 50-70℃
    3. ABS:100-125℃ ( 110℃ is recommended )
    4. PC:100-130℃ ( 120℃ is recommended )
    5. Nylon:90-120℃ ( 110℃ is recommended )
    6. PP:100-130℃ ( 120℃ is recommended )
    7. PETG: 50-70℃
  • Comes with two extra stickers for cold plate printing for ABS and PETG.
  • packaged weight is 600g (235) 930g (310)
Save this product for later